Open House Recipe Request
Two Tags

Penguin Gift Card Holder

Penguin gift card At the STAMP CLUB OPEN HOUSE last weekend we had three MAKE AND TAKES.  This cute little penguin was one of them.  It is a gift card holder and I will be making some this week for  my nephews, Mark and Micheal, and my niece, Katherine.  It is quick and easy ~ here are the Stampin' Up! 'ingredients" ~

Cut:   1.   Basic Black card stock ~ 4” x 4” square, corners rounded plus

                   2 large ovals

          2.  Whisper White ~ 4.25” X 5.5” cut with Top Note Die

          3.  Tangerine Tango ~ punch one Curly Label and cut in half plus

                   1 large oval for the beak

          4.  12” Real Red Grosgrain Ribbon, tie and cut on side

          5.  Rose Red ~ ½ Top Note Die to hold the gift card

          6.  Pear Pizzazz card stock ~ 4.25” x 11”, scored and folded


Punches:  Curly Label Punch, #119851;1 ¾” x 7/8” Oval Punch, #119855,

          Page 202 – 205; 3/16” Corner Small, #119871

Ribbon:  Real Red 5/8” Grosgrain, #109052, page 191

Die:  Top Note Die, #113463, page 207

Accessories:  Sticky Strip, #104294’ Dimensionals, #104430, page 197;

          Bone Folder, #102300, page 198; Goggle Eyes ~ craft store


Hint:  To adhere the inside card holder, use small pieces of Sticky Strip on 3 sides. 

Penquin gift card inside


Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been posted. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)